Page 1 of 4
Pivot Table Quick Start Guide
1. Attach Scanners to pivot mount. Refer to separate document.
IMPORTANT !!!
Before turning off power to the fixture, the fixture must not be rotating. This can be
accomplished with the Speed Control knob or HALT buttons located on the side panels.
This will allow the fixture to coast to a gentle stop. Otherwise, if A/C power is removed while
rotating, the fixture can stop suddenly and cause damage if the scanners are powered.
Shutdown procedure
1. Press the HALT button. The button should lock in place and the fixture will coast to a gentle
stop.
2. Adjust the Speed Control to the minimum setting. This is not necessary, but will ensure a
controlled start up condition.
3. Press the A/C power switch OFF, located on the side panel.
Startup procedure
1. Adjust the Speed Control to the minimum setting. This is not necessary, but will ensure a
controlled start up condition.
2. Press the A/C power switch ON, located on the side panel.
3. Release the HALT buttons by turning clockwise.
4. Adjust the Rotation Control to the desired s/- 0
o
to +/- 90
o
5. Adjust the Speed Control to the desired setting.
Emergency procedure
1. Press one of the HALT buttons located on the left or right side panel. The button will lock in
place and the fixture will coast to a gentle stop.
2. Press the A/C power switch OFF located on the side panel.
