LTI TruPoint 200h User’s Manual • Section 5 - Function Menu
Page 47
Copyright (c)[2020] Laser Technology, Inc. All Rights Reserved. Unauthorized duplication, in whole or in part is strictly prohibited.
Area Routine
Determines the area of a rectangle or square in two measurements.
The Area calculations can use either the slope distance
or horizontal distance
of each shot for the length and width. Once on the Area function, press the
and
buttons
before taking first measurement to navigate between the two.
Main Display Routine
1.
Short press the
button and use the navigation buttons to highlight
the Area Routine icon
.
2.
Press the
button to enter the Area measurement routine.
3.
Select your first target and press the
button, the laser pointer is active and the
laser indicator
will be displayed while the laser pointer is on.
•
Aim the laser pointer to the target.
•
Shot 1 is displayed in lower message area prompting you to
measure the Slope Distance to the “face” of the target
4.
Press-and-hold the
button, the laser will remain active for a maximum of 10 seconds
while acquiring data about the target. The measured slope distance appears in the main display
once the target is acquired. Shot 2 is then displayed in the lower message area.
5.
Aim the laser pointer to the other portion of the room/target and take the second measurement.
6.
Press-and-hold the
button, the laser will remain active for a maximum of 10 seconds
while acquiring data about the target. The measured slope distance appears in the main display
once the target is acquired and the calculated Area result is displayed.
**Draft B**
