LTI TruPoint 200h User’s Manual • Section 5 - Function Menu
Page 46
Copyright (c)[2020] Laser Technology, Inc. All Rights Reserved. Unauthorized duplication, in whole or in part is strictly prohibited.
Main Display Routine
1.
Select your first target and press the
button, the laser pointer is active and laser indicator
will be display the pointer is on. Aim the laser pointer to the target. Shot 1 is displayed in lower
message area prompting you to measure the Distance to the target.
2.
Press-and-hold the
button, the laser will remain active for a maximum of 10 seconds
while acquiring data about the target. The measured horizontal, slope & vertical distance
and inclination appear in the main display once the target is acquired for 2 seconds.
3.
The measurements are cleared from the Shot 1 and Shot 2 is displayed in lower message area
prompting you to take the seconds measurement; using the laser pointer, aim to the second
target.
4.
Press-and-hold the
button, the laser will remain active for a maximum of 10 seconds
while acquiring data about the target. The measured horizontal, slope & vertical distance and
inclination appears in the main display once the target is acquired for 2 seconds.
5.
The laser pointer is turned off, the Missing Line value results are displayed with RESULT in the
lower message area and the results are from Shot 1 to Shot 2.
Button sequence during the 2D Missing Line routine:
•
Pressing the back key
clears the last measurement and
allows you to reshoot that measurement.
•
Pressing the
button soft key, exits the 2D Missing Line function
and goes to main measurement screen.
•
Press the
button to clear last measurement and to
re-shoot the previous point.
•
When the 2D Missing Line result is displayed, just press the
button to start the routine and repeat the steps.
**Draft B**
