Page 8 - Laser Technology, Inc. LTI 20/20 TruSpeed Metric User’s Manual 3rd Edition
Copyright (c)[2013] Laser Technology, Inc. All rights reserved. Unauthorized duplication, in whole or in part, is strictly prohibited
Installing / Removing the Batteries
Two C cell batteries are required to power the TruSpeed. The batteries are
located in the Battery Tube inside the Handle.
LTI strongly recommends using
standard-design C cell alkaline batteries.
If you use rechargeable batteries, they
must be shaped like Figure #6B.
If you use any battery shaped like Figure
#6A, it will cause fatal damage to the laser
regardless if powered on or not. Regardless
of chemical make-up, the use of any battery
shaped like Figure #6A, will void the
warranty, any pursuant damage caused to
the transistor, and main power supply chip
will not be handled as a warranty repair.
Removing the Battery Tube from the Handle
1. Hold the TruSpeed with one hand and
hold the bottom of the Handle with
your other hand.
2. Press the Battery Release, the
black button on both sides of the
TruSpeed, just behind the TRIGGER.
3. Slide the Battery Tube out of the
Battery Compartment.
Inserting the Batteries in Battery Tube
1. With the positive end of the
battery pointing toward the
bottom of the Battery Tube,
align the battery with the
opening of the Battery Tube
as shown in Figure #8A and
B.
2. Insert the battery into the
Battery Tube and slide the
battery to the top of the tube.
3. Position the second battery as
described in step #1 and
insert the battery into the
tube as shown in Figure #8C.
Figure #6
Figure #7
Figure #8
