WL-LED-12-M
CAUTION:
Read all instructions and warnings before operating.
SAVE THESE INSTRUCTIONS! READ ALL INSTRUCTIONS!
WARNING:
To avoid serious injury or death from electrical shock or fire:
1.
DO NOT handle this fixture or try to plug it in when your hands are wet or damp or
when you are standing on a wet or damp surface or in water.
2.
This fixture must always be used in accordance with all electrical and safety codes and
ordinances, including the most recent National Electric Code (NEC) and with the
Occupational Safety and Health Act (OSHA) Volume 1 on General Industry Standards
and interpretations.
3.
Always make certain that the power source conforms to the requirements on the
fixture.
4.
Always disconnect the power before servicing or inspecting the fixture for any reason.
5.
The charging transformer supplied with this unit is only for use on 110-125V circuits.
6.
Fixture is not waterproof and is not intended for use in showers, saunas or in
potentially wet locations. The entry of moisture into the light may cause damage and
void warranty.
7.
This light is intended for use as general lighting. DO NOT charge the light in the presents
of flammable or explosive gases.
8.
Never operate the light with the clear protective lens removed.
9.
Never look directly into light source. LEDs are extremely bright and can damage eyes
with prolonged exposure.
10.
Keep away from heating vents, radiators, or other sources of heat.
11.
Do not dispose of dead battery packs in a fire or by burning. NiMH batteries may be
disposed of in standard municipal waste system.
12.
Keep out of reach of children.
CHARGING INSTRUCTIONS
WARNING:
Do not allow anything to cover the light while charging to prevent heat buildup – It
is normal for the batteries to become warm during recharge.
Plug transformer into any 110-120 V household electrical outlet. Pull protective cover to expose
socket at the base of the light. Plug transformer cord plug into the socket. The red LED on the
light will indicate that the light is charging. It will turn green when the light is fully charged.
After charging is complete, unplug the cord and remove the transformer from outlet.
Always replace the cover after completion of charging to keep dirt and moisture from entering
the socket.
NOTE:
To obtain best results of the battery life time, recharge the batteries before completely
discharged. Batteries cannot be overcharged. Unit is installed with overcharge protection.
