Q
ui
ck
S
ta
rt
G
ui
de
WARNING:
Use the ALTITRACK™ at your own risk.
The Quick Start Guide enables you to set-up the basic functions of the
Altitrack to make the first jump. For detailed description of menus,
functions and features, please read the manual.
Analog and digital face
Analog face
1. Right Front Button
2. Left Front Button
3. ACCESS indication (Flashes every 15 seconds when unit is powered ON)
4. Low battery indicator
Digital face
6. Rubber support
7. Battery compartment
8. LCD display
9. Left button
10. Mode button
11. Right button
12. Reset button (below battery cover)
Power ON
The ALTITRACK has been powered OFF prior to shipping from our factory. To turn the
power ON, press and hold any button until the unit beeps, then release the button.
The ALTITRACK runs a self-test and moves the pointer from ”6” to zero.
The unit displays “Logbook screen # 1”. (Main information)” on the LCD.
The ALTITRACK uses very little battery power and does not need to be switched OFF.
However, we recommend that you switch OFF the ALTITRACK when traveling on
commercial flights, when driving in mountanious areas and when the jump season is
over. To power OFF, see manual.
Road Map
It is recommended that you familiarize yourself with the
ALTITRACK ROAD MAP
which
is a very helpful tool when using the ALTITRACK for the first time.
ALTITRACK Settings
The ALTITRACK can be customised to your personal settings.
The Factory default settings are as follows
Temperature:
Celsius
Canopy Log:
Enabled
Feet / Meter:
Feet
Mph / Kmh:
Mph
TAS / SAS:
TAS
Sound ON / OFF:
ON
Type of Dive:
0
Date format:
2006:01:01 (year, month, date)
Time format:
00:00:00 (hours, minutes, seconds)
If you want to customise each setting, please read the manual. If you only want to
customise the most important settings prior to the first jump (your total number of
jumps, Time and Date), please go to section ”Customising the ALTITRACK Settings”
in this Quick Start Guide.
Otherwise, continue reading below.
Zeroing the ALTITRACK
Explanation:
The ALTITRACK continuously adjusts itself to the local elevation and the pointer is
at the zero “0” position. If the pointer is not within one width from “0” prior to
jumping, the unit has not yet adjusted itself to the local elevation and it must be
manually zeroed.
To manually zero the ALTITRACK you must first perform ACCESS:
1. Press the Left Front Button and release quickly
2. When the green ACCESS indicator light on the front of the ALTITRACK dial
illuminates, immediately press the Left Front Button again and keep it
pressed (ACCESS indicator light goes OFF)
3. When the ACCESS indicator illuminates again, release the button immediately
Then move the pointer to “0”
by using the Right Front Button or Left Front Button.
The unit is now zeroed and the LCD displays “0” altitude.
Example
No data stored
3
4
1
2
6
7
8
9
10
11
12
