Ediz. 010 - 09/2015
www.larius.eu
LARIUS MINI MIX
9
To avoid electric shock when disassembling or checking the elec-
tronic equipment, wait 5 minutes after having disconnected the
power supply cable, so that the electricity stored in the condensers
while working can be dissipated.
Also check the condition of the earth cable to avoid any risk of
shock.
Before carrying out any checks on the machine
(maintenance, cleaning, or replacing parts) switch
off the machine and wait until it has stopped alto-
gether.
While checking stay away from electrical or moving
parts to avoid any risk of shock or crushing of hands.
WARNING :
•
DO NOT modify the plug for the earth socket
in any way.
•
ONLY use electrical connections that are
earthed.
•
Make sure that any earth extension cords are
in good condition.
•
ONLY use three-core extension cables.
•
Avoid direct contact with the rain. Keep the
equipment in a dry place.
CONNECTING THE EQUIPMENT TO THE PNEUMATIC LINE
Make sure that the air line to be connected to the machine is
capable of constantly providing pressure at 7 bar.
Before opening the air line, turn the ball valve (
F7
) on the general
regulator (
F8
) to its closed position
(horizontal tap)
.
After having opened the machine's air supply, open the valve
completely and set the regulator to maximum.
WASHING OF THE NEW EQUIPMENT
•
The machine has been tested at the manufacturer’s facilities.
Perform a wash cycle with the paint thinner before suctioning
any product.
•
Place the suction tubes in the solvent containers or else
pour solvent into the gravity tanks.
•
Make sure that all of the taps are closed.
•
Circulate the solvent within the output pumps and afterwards
within the entire system.
•
Open the machine’s intake taps, as well as those at the
flowmeter intake and leave the relative bleeder valves closed.
•
Activate an automatic work cycle and circulate the solvent
until it comes out of the machine clean.
•
Stop the automatic work cycle and activate a wash cycle.
This cycle will help the user set all of the wash settings so
that that machine will be predisposed to perform future wash
cycles during working phases.
PNEUMATIC CONNECTION
The machine must be connected to the compressed air feeding
system, which is necessary for the pneumatic interlocking.
The connection must be carried out in the following way:
•
Connect the air feeding pipe (
F9)
to the joint (
F10
).
It is advisable to install an on-off valve on the frontal
part of the machine
F7
F8
F9
F10
Содержание Mini Mix
Страница 1: ...ITALIANO Ediz 010 09 2015 OPERATING AND MAINTENANCE INSTRUCTION Larius Mini Mix www larius eu ...
Страница 31: ...Ediz 010 09 2015 www larius eu LARIUS MINI MIX 29 W h i t e p a g e i n t e n t i o n a r y ...
Страница 46: ...PAINT SPRAYING EQUIPMENT L innovazione Quella vera ...
Страница 47: ...PAINT SPRAYING EQUIPMENT L innovazione Quella vera ...
