Lapple FIBRO FIBROTOR EM Series, Руководство по сборке и эксплуатации

Страница: 10 / 72

1 INTRODUCTION
1.4 APPLICABLE DOCUMENTS
FIBROTOR
10 | 72
The operator of the machine described in this document bears the responsibility for
any injuries and damages caused by its improper use.
1.4
Applicable documents
Along with this manual, other applicable documents are necessary for the safe
operation of the machine. The data in these documents must be observed.

Instruction for the assembly of a partly completed machine according to
Guideline 2006/42/EG

Electric diagram

Hydraulic diagram

Pneumatic diagram

Drawings
1.5
Structure
The structural design is characterised by a rigid mechanical structure. The basic
device is comprised of the housing, table top, bearings, cam drive, drive motor with
gearbox and holding brake. Horizontal and vertical use with several motor layouts is
possible.
Additional component assemblies are available if the structure is to be extended.
The rotary table may also be used as a built-in table.
1.5.1
Bearing
The arrangement is subject to a service life of MTTF = 20,000 h.
1.5.2
Path of motion
The figure with the operating curve ensures that the operation is smooth and
impact-free, even in the event of considerable loads (see the evolution of the
operating cam). The indexing time can be taken from the load diagram in
accordance with the moment of inertia.
The time for the cam rotation is divided into a stipulated ratio between indexing and
holding time.
1.5.3
Drive, cam
The operation is generated from the drive motor via a gearbox and the cam drive to
the table top. The cam rollers are pretensioned on both sides on the operating cam
in the holding phase. This enables the play-free transition from standstill to
movement and vice versa.