Lapple FIBRO FIBROTOR EM.NC Series, Руководство по сборке и эксплуатации

Страница: 41 / 60

9 REPAIR
9.2 MAINTENANCE WORK
FIBROTOR 41 | 60
When maintaining the rotary table, the following must be ensured:
•
all work steps are performed in the specified order.
After the maintenance work has been completed, it must be checked whether
•
the work has been performed completely.
•
all foreign bodies have been removed from the work area.
•
the safety devices have been mounted properly and are functioning.
The operator must establish the cleaning intervals.
9.2.2.1 Long-term lubrication
The rotary table is delivered filled with suitable synthetic oil. The gearboxis filled with
synthetic gearbox oil. The lubricants are designed for a service life of at least
20,000 operating hours.
A change in lubricant is only required in the event of coolant and lubricant ingress,
as well as in the event of a general overhaul of the device. Contact our customer
service in this regard.

It is recommendable to thoroughly clean the gearbox when changing the lubricant.
The rolling bearings filled with grease must be cleaned every 20,000 operating
hours and filled with new grease. Whilst doing so, ensure that the bearing space is
filled with approx. 1/3 grease.
Synthetic and mineral lubricants must not be mixed with
each other.
In the case of ambient temperatures below
– 20°C and
above + 60°C rotary shaft seals with special material quality must be used.
In the case of external reservoirs observe their lubrication
instructions.
9.2.2.1 Mounting position of horizontal table top
The rotary table is delivered filled with suitable synthetic oil. The gearboxis filled with
synthetic gearbox oil.
9.2.2.2 Mounting position of vertical and upside-down table top
The control cam and drive rollers of the rotary table are greased with
Arcanol
MULTITOP
before delivery.