Lapple FIBRO FIBROTOR EM.NC Series, Руководство по сборке и эксплуатации

Страница: 32 / 60

5 ASSEMBLY
5.4 MODIFICATIONS AND ALTERATIONS
FIBROTOR
32 | 60
Transport the rotary table to the assembly site in compliance with the safety
instructions and transport regulations.
Sagging load. Do not hold between the rotary table and the installation surface.
Crushing of hands or fingers.

Lower the machine carefully and place.

Remove the transport belts.

Connect sealing air for rotary table (see chapter 3.4 Sealing air) and measuring
system.

The type and positions of the connections must be taken from the dimensional
drawing and the electric diagram in the appendix.

The information regarding the type, size and other data for pneumatic, hydraulic,
water and electrical connections must be taken from the diagrams and drawings
enclosed in the appendix.

Check function:

– Functional sequence (see chapter 7.3 Operating modes)

– Measuring system
5.4
Modifications and alterations
5.4.1
Admissible modifications and alterations
The admissible alterations can affect the performance of the rotary table. The
admissible alterations are:
•
Installing tools, workpieces and devices on the switching plate.
•
Attaching hoses, pneumatic lines or cables to the rotary table.

The hoses, pneumatic lines or cables must be mounted in such a way that
they do not impede the rotational movements or cause motion errors of the
rotary table.
5.4.2
Forbidden modifications and alterations
•
Modifications of the connection cable between the rotary table and the control
system
•
Modification of any access panelling on the rotary table or the drive system
•
Modifications (including drilling and cutting) of any part of the rotary table
surface
•
Modifications of any electronic component or printed circuit board
•
Laying of additional hoses, air ducts or wires inside the rotary table
•
Changing the system pressure of the hydraulic clamping