LAPIS Semiconductor ML7105, Руководство по оборудованию, Страница: 9 / 14

ML7105 USB BOARD Hardware Manual
3. Operation procedure
4
3. Operation procedure
3.1 First Setup
①
Install driver software for USB serial IC. Virtual Com Port driver can be downloaded from following link.
②
Insert USB dongle into USB connector on your PC.
ML7105 USB Board will be ready to use now.
Please refer to ML7105 Evaluation kit PC application manual for further operation.
USB dongle require UART interface, it is important to select module with UART interface marked as shown below.
Figure 3-1 ML7105 Wireless module in BACI mode with UART I/F
3.2 Operating mode
ML7105 USB Board supports following operating mode.
Pin No Descritpion
BACI mode*1
Support Bluetooth Application Controller Interface (BACI) API.
Detail of BACI commands and events are described in Bluetooth Application Controller
Interface Command Manual.pdf
HCI mode*1 Support Host Controller Interface (HCI), Bluetooth stadndard interface.
ICE mode Enable access to internal CPU via ICE. Reserved for future use.
3.3 Switching BACI/HCI mode
Configuration either BACI mode or HCI mode will be done by configuration parameter stored in EEPROM memory.