ML62Q1347 Reference Board User’s Manual
FEBL62Q1347RB
4
2.2. Connection for EASE1000 (CNE)
EASE1000 can be used if J1 and J2 jumper are set to “CNE”.
Fig. 3 EASE1000 Interface
[Note]
P00/TEST0 pin:
P00/TEST0 pin of ML62Q1347 is initially set as a pull-up input mode
When using EASE1000, do not set it as an output mode by using an application program, otherwise EASE1000
cannot communicate with the ML62Q1347.
2.3. LED (P20, P21, P22)
The P20-P22 pins of the ML62Q1347 are ports that can directly drive LED. The Ports are connected to the LEDs through
jumper-chip. Remove the jumper-chip when not using the LEDs.
Fig. 4 Jumper-chip removal of LEDs
CNE
ML62Q1347
RESET_N
P00/TEST0
10k
VDD
C
J1
USR
CNE
RST_OUT/SCK
SDATA
5
7
CN1
RESET_N
P00/TEST0
6
7
J2
C
USR
CNE
Remove when not
using the LEDs
