ⓒ
2019
LaON
Technology Co., Ltd. All rights reserved.
25
Beltpack operation
Power On/Off
Power On
Press the PWR button (#4) longer than three seconds to turn on the Beltpack
. A voice message ‘Power on’ will
be heard from the headset, and the red Talk light adjacent to the Talk button will go on. After a few seconds,
talk light will be changed to green slow flashing, indicating the Beltpack is ready to use, if the pairing with the
Base Station is properly done.
Power Off
Press and hold the PWR
button for approximately two seconds. A voice message ‘Power off’ will be heard in
the headset and then the green slow flashing Talk light will go off.
Normal menu on the Beltpack’s upper screen
The item
‘A’
indicates the Beltpack’s Received Signal Strength Indication (RSSI) level. The RSSI level is
presented graphically
.
The item
‘B’
indicates that the applicable Beltpack is connected to which device. When the Beltpack is
connected to the Mobile
Station, ‘MS’ will be shown. When the Beltpack is connected to the Master Beltpack,
‘MB’ will be shown.
The item
‘C’
indicates the Communication group of the Talk channel. The numbers 1 through 2 stands for the
number of the Communication groups
.
The item
‘D’
indicates the Beltpack’s battery level. The battery level is presented graphically.
The item
‘E’
indicates the Beltpack’s label. While the Lock is set, ‘Lock’ will be indicated here to instead.
The item
‘F’
indicates Beltpack’s operation mode. If the Talk channel is in the Latched mode, ‘HF on’ (Hands free
on) appears on the display. If the Talk channel is in the push-to-tal
k mode, ‘HF off’ (Hands Free off) appears on
the display.
Lock the menu
The Beltpack keys can be locked to avoid any wrong operation by accident. Press and hold the PWR button (#4)
of the Beltpack and quickly press GRP button (#5) within one second and release both. And the keys will be
locked. In this mode, Set (#7) and GRP (#5) button will be inactivated and the Normal menu of the Beltpack will
show the text ‘Lock’ in the bottom-right of the screen. To unlock, press and hold the PWR button (#4) and quickly
press GRP button (#5) within one second and release both again.
NOTE:
Quickly operate to press the two buttons as instructed above otherwise, pressing PWR button longer
than 2 seconds will make the Beltpack turned off.
NOTE:
When the Beltpack is in Two groups mode, GRP button works as Talk button for the latter group selected
in Two groups menu screen.
NOTE:
This setting is valid regardless of the belt pack reboot.
Figure 4-21. Normal menu
A
B
C
D
F
E
MS
9
10
11
1
4
2
7
3
5
6
8
