8: Channel Mode: Channel Configuration
XPress™ DR Industrial Device Server User Guide
53
ATVn
Enables 1-character response or full verbose.
n=0 enables 1-character response.
n=1 enables full verbose.
Note:
These AT commands are only recognized as single commands like ATE0 or ATV1;
compound commands such as ATE0V1 are not recognized. All other AT commands with Modem
Mode set to full verbose acknowledge with an OK, but no action is taken.
Send the Escape Sequence (+++) in Modem Mode
Send ‘+++’ in Modem Mode (Y) ? _
Disable or enable the XPress DR device server’s ability to send the escape sequence. The
default setting is
Y
(Yes) (send the escape sequence).
Show IP addr after 'RING'
Show IP addr after 'RING' (Y) ?
Disable or enable the XPress DR unit's ability to show the IP address after RING in Modem
Mode. The default is
Y
(Yes), to show the IP address.
Auto Increment Source Port
Auto increment source port (N) ? _
Y
(Yes) auto increment the source port. The XPress DR increments the port number used with
each new connection.
Remote IP Address
This is the destination IP address used with an outgoing connection.
Remote IP Address : (000) .(000) .(000) .(000)
Remote Port
The remote TCP port number must be set for the unit to make outgoing connections. This
parameter defines the port number on the target host to which a connection is attempted.
Remote Port (0) ?
Note:
To connect an ASCII terminal to a host using the unit for login purposes, use the remote
port number 23 (Internet standard port number for Telnet services).
DisConnMode
DTR is hardwired to +12VDC. The Disconnect with DTR drop option is inactive.
Note:
Table F-1 Binary to Hexadecimal Conversion Table
DisConnMode (40) ? (Telnet Com Port Cntrl Enabled)
Table 8-8 Disconnect Mode Options
Disconnect Mode Option
7 6
5
4 3 2
1 0
Disconnect with DTR drop
(6)
1
Ignore DTR
0
Telnet mode and terminal type
setup
(1)
1
