Lantronix
SM24TBT2DPA and SM24TBT2DPB Web User Guide
3-11 LLDP
3-11.1 Neighbors
This page provides a status overview of all LLDP neighbors. The LLDP Remote Device Summary table
contains a row for each port on which an LLDP neighbor is detected. If your network has no devices that
support LLDP, then the table displays “
No LLDP neighbor information found
”.
To show LLDP neighbors:
1. Click Monitor, LLDP, Neighbors.
2. Click Refresh to manually update the webpage or click Auto-refresh to automatically update the
webpage every 3 seconds.
Figure 3-11.1: LLDP Neighbors Information page
Parameter descriptions:
Local Port:
The port on which the LLDP frame was received.
Chassis ID:
The identification of the neighbor’s LLDP frames.
Port ID:
The Remote Port ID is the identification of the neighbor port (a switch port # or the MAC address
or the neighbor device).
Port Description:
The port description advertised by the neighbor unit (e.g.,
Port # 4
or
eth0
).
System Name:
The name advertised by the neighbor unit (e.g., SM24TBT2DPA or a camera model #).
System Capabilities:
Displays the neighbor unit's capabilities (e.g., Other, Repeater, Bridge, WLAN
Access Point, Router, Telephone, DOCSIS cable device, Station only, and Reserved).
+
: When a capability is enabled, the capability is followed by (
+
).
-
: If the capability is disabled, the capability is followed by a (
-
).
System
Description
: Displays a description of the neighbor device (e.g.,
Managed Switch
…,
Network
Camera
…, etc.).
Management Address:
The neighbor unit's IP address that is used for higher layer entities to assist
discovery by the network management. This could show the neighbor’s IP address and provide a link to
the device. If you click the linked IP address a login page displays to let you log in to and set up the
discovered neighbor device. Sample screens are shown below.
Buttons
Auto-refresh:
Check this box to refresh the page automatically every 3 seconds.
Refresh
: Click to refresh the page immediately.