Lantronix SM16TAT2SA, Инструкция по установке, Страница: 15 / 30

Lantronix SMxTAT2SA Install Guide
33716 Rev. L https://www.lantronix.com/ 15
When PoE Mode LED Lit
LED Color State
Description
RJ45 Ports
Green On
The port is enabled and supplying power to connected device.
Amber On
An abnormal state, such as overload status, has been detected in the
switch.
-- Off
The port has no active network cable connected, or it is not connected a
PoE PD device. Otherwise, the port may have been disabled through the
switch user interface.
Mode/Reset Button
By pressing the Mode/Reset button for certain period of time, you can perform these tasks.
•
Change Port Status LED Mode : to read the port status correctly in the two different modes (PoE mode
or Link/Act/Speed mode).
• Reset the Switch : to reboot and get the switch back to the previous configuration settings saved. The First
Time Wizard displays again after pressing the Reset button.
•
Restore the Switch to Factory Defaults
: to restore the original factory default settings back to the switch.
Note
: Based on the table below, you can judge which task is being performed by reading the LED behaviors
while pressing the Mode/Reset button. Once the LED behaviors are correctly displayed, you may release the
button.
Table 4: Mode/Reset Button Descriptions
Task to Perform Press Button for ..
SYS LED
Behavior
Port Status LED
Behavior
Change LED Mode 0 ~ 2 seconds
ON
Green
LED status will be changed
according the mode selected.
Reset the Switch 2 ~ 7 seconds
Blinking
Green
ALL LEDs Are OFF.
Restore to Defaults 7 ~ 12 seconds
Blinking
Green
ALL LEDs Stay ON.
Press the
Reset
button until all port LEDs light, then release the
Reset
button. This will set the unit back to its
factory default IP address; log back in to display the startup wizard.