Lantronix
SISPM1040-3xxx-L Install Guide
33762 Rev. G
Page
39
of
48
If your PC is configured correctly, you will see the Login page of the switch as shown below.
If you do not see the above Login page, try these steps:
Refresh the web page.
Check to see if there is an IP conflict issue.
Clear browser cookies and temporary internet files.
Check your PC settings again and repeat step 2.
6.
Enter the factory default username (
admin
) and password (
admin
) on login page.
7.
Click “Login” to log into the switch. See the
Web User Guide
for additional information.
Initial Switch Configuration via CLI
1.
Use an RJ-45 cable to connect a terminal or PC/terminal emulator to the switch port to access the CLI.
2.
Attach the RJ-45 serial port on the switch front panel to the cable for Telnet/CLI configuration.
3.
Attach the other end of the DB-9 cable to a PC running Telnet or a terminal emulation program such as
HyperTerminal or TeraTerm.
4.
After powering up the switch for the first time, you can perform the initial switch configuration using the CLI
(Command Line Interface). For managing other switch features, see the
CLI Reference
for details.
