Lantronix MSS1-T, Справочное руководство

Страница: 61 / 117

Commands
6 - 1
6 - Commands
This chapter describes the MSS command set. Each command and its basic syntax is shown, as
well as whether the command is restricted to the privileged user. Where applicable, default
settings are given.
When reading through this chapter, take note of the following:
• Commands are listed in alphabetical order.
• Some commands do not apply to the MSS485, and are so noted.
• Commands and keywords appear in BOLD UPPERCASE.
• User-entered parameters appear in italics. You must replace the itali-
cized word with an appropriate entry.
• When two or more parameters appear in curly {braces}, you must
choose one and only one of the items within each set of braces to com-
plete the command.
• Parameters that appear in [brackets] are optional. If more than one
parameter appears in a single set of brackets, only one parameter may
be chosen at a time. Single parameters enclosed in brackets may be
omitted from the command, or used in combination with one another.
• The MSS has a reduced command set from the EPS, ETS, and MPS
product lines. Change commands replace the Set/Define Server and
Set/Define Port commands used in the earlier products.
A single Change command will take effect immediately (like a Set com-
mand), and will remain in effect upon reboot until another Change
command is issued (like a Define command). The Set Privileged com-
mand is still used, however.