Lantronix
M/GE-PSW-PSE-01 User Guide
Page
7
of
8
The M/GE-PSW-PSE-01 is an 802.3at device; it will only provide power on one pair. Highlighted in yellow below is
the M/GE-PSW-PSE-01 pinout.
PSE Pinout Alternatives
:
Conductor Alternative A (MDI-X)
Alternative A (MDI)
Alternative B (All)
1
Negative
VPSE
Positive
VPSE
2
Negative
VPSE
Positive
VPSE
3
Positive
VPSE
Negative
VPSE
4
Positive
VPSE
5
Positive
VPSE
6
Positive
VPSE
Negative
VPSE
7
Negative
VPSE
8
Negative
VPSE
Note
:
All PD devices must accept power on either pair (Alternative A or Alternative B).
Installation
Warning
: Do not attempt to open the enclosure or service the power supply. Opening the enclosure may cause
serious injury or death. There are no user replaceable or serviceable part in this device.
Cautions and Warnings
Cautions
indicate that there is the possibility of poor equipment performance or potential damage to the
equipment.
Warnings
indicate that there is the possibility of injury to person.
Cautions and Warnings appear here and may appear throughout this manual where appropriate. Failure to read
and understand the information identified by this symbol could result in poor equipment performance, damage to
the equipment, or injury to persons.
Caution
: While installing or servicing the power module, wear a grounding device and observe all electrostatic
discharge precautions. Failure to observe this caution could result in damage to, or failure of the power module.
Warning
: Do not connect the power module to an external power source before installing it into the chassis. Failure
to observe this warning could result in an electrical shock, even death.
WARNING
: Equipment grounding is vital to ensure safe operation. The installer must ensure that the power module
is properly grounded during and after installation. Failure to observe this warning could result in an electric shock,
even death.
WARNING
: A readily accessible, suitable National Electrical Code (NEC) or local electrical code approved
disconnect device and branch-circuit protector must be part of the building's installed wiring to accommodate
permanently connected equipment. Failure to observe this warning could result in an electric shock, even death.
WARNING
: Turn any external power source OFF and ensure that the power module is disconnected from the
external power source before performing any maintenance. Failure to observe this warning could result in an
electrical shock, even death.
WARNING
: Ensure that the disconnect device for the external power source is OPEN
(turned OFF)
before
disconnecting or connecting the power leads to the power module. Failure to observe this warning could result in an
electric shock, even death. See Electrical Safety Warnings for Electrical Safety Warnings translated into multiple
languages.
