Lantronix FOX3-2G Series, Руководство по оборудованию

Страница: 37 / 51

Hardware Interfaces
FOX3-2G/3G/4G Series Hardware Manual 37
7.4. LED indicators
The actual state of the FOX3-2G/3G/4G can be displayed by three LED’s on the front panel of the
unit. These programmable and accessible LEDs can be interfaced to the build-in components to
show their state. References how to customize the device configuration can be found in the FOX3-
2G/3G/4G software manual
“AVL_PFAL_Configuration_Command_Set.pdf
” .
Figure 16: View of LED indicators
To turn on one of these LEDs, use the following command:
$PFAL,IO 11 .Set=high // 11=LED Orange;
$PFAL,IO 12 .Set= hpulse,2000 // 12=LED Green
;
$PFAL,IO 13 .Set=cyclic,2000,1000 // 13=LED Red;
To turn off these LEDs, use the following command with corresponding index number:
$PFAL,IO [11,12,13] .Set=low
7.5. 10pin mini-USB port
This port supports a SPI and a USB 2.0 interface. The following table gives you an overview about the
provided pins on this 10pin mini-USB-port.
Figure 17:
Pin assignments of the 10pin mini-USB port.
This table shows the pinout of 10pin mini-USB connector.
PIN NAME DIRECTION DESCRIPTION LEVEL