ContiPressureCheck™ System Integration into FOX3-2G/3G/4G Series
15
2.6
Installation steps
✓
Insert your SIM card (supporting data) into the SIM slot of the FOX3/-3G/-4G device (refer to
the hardware manual of the FOX3-2G/3G/4G devices).
✓
Connect the CA68 cable (installation and power cable) to the main port (8pin connector).
✓
Power off your vehicle. A standard CAN Bus will have a 120 ohm resistor termination at each
end of the bus. Before connecting a FOX3/-3G/4G device to the CAN-H and CAN-L of the FMS
gateway in your truck, check with an ohmmeter between the CAN-H and CAN-L if they are
terminated at both ends by a 120-ohm resistor. If you read approximately 60 ohms, this
means that two 120 ohm resistors are in parallel. If you read 120 ohms, one of the
terminations is missing.
✓
Connect the
CAN_ Low
pin of this cable to the
CAN-L
of the FMS gateway on your truck.
✓
Connect the
CAN_High
pin of this cable to the
CAN-H
of the FMS gateway on your truck.
✓
Apply power to the device by connecting the BROWN wire of this cable to KL 31 (GND) and
the RED wire of this cable to KL 30 (+12/24VDC source
in the vehicle’s fuse box
).
✓
Connect the IGN pin (Blue wire) of this cable to the KL 15 (ignition of the vehicle).
✓
More information on how to install properly Lantronix devices in the vehicles is available in a
separate
document,
see
chapter
Error!
Reference
source
not
found.
,
“
AppNotes_AVL_Installation_Guide.pdf
”.
✓
The FOX3 device is now ready to receive the FMS data from the CPC system.
Fig. 4
: Installation of FOX3-2G/3G/4G series to the FMS gateway.
