8: Line and Tunnel Settings
EDS1100/2100 Device Server User Guide
47
4. Enter or modify the following settings:
Table 8-5 Line Command Mode
Line Command Mode
Setting the Command Mode
enables the CLI on the serial
line.
To configure Command
Mode on a specific line:
1. Select
Line
on the menu
bar, if you are not already
in the Line web page.
2. Select a line number at the
top of the page.
3. Select
Command Mode
.
The Command Mode page
for the selected line
appears.
Figure 8-4 Line 1 Command Mode
Line – Command Mode
Settings
Description
Mode
Select the method of enabling Command Mode or choose to disable Command
Mode.
Always
= immediately enables Command Mode for the serial line.
Use Serial String
= enables Command Mode when the serial string is read
on the serial line during boot time.
Disabled
= turns off Command Mode.
Wait Time
Enter the wait time for the serial string during boot-up in milliseconds.
Serial String
Enter the serial string characters. Select a string type.
Text
= string of bytes that must be read on the Serial Line during boot time to
enable Command Mode. It may contain a time element in x milliseconds, in
the format {x}, to specify a required delay.
Binary
= string of characters representing byte values where each
hexadecimal byte value starts with \0x and each decimal byte value starts
with \.
Echo Serial String
Select Yes to enable echoing of the serial string at boot-up.
Содержание EDS2100
Страница 1: ...Part Number 900 567 Revision C April 2016 EDS1100 2100 Device Server User Guide...
Страница 32: ...4 Installation of EDS2100 EDS1100 2100 Device Server User Guide 32 Figure 4 8 EDS2100 Connections...
Страница 120: ...13 Maintenance and Diagnostics Settings EDS1100 2100 Device Server User Guide 120 Figure 13 30 Processes...
Страница 124: ...14 Advanced Settings EDS1100 2100 Device Server User Guide 124 Figure 14 1 Email Statistics...
