Lantech IPGS-3 Series, Руководство пользователя

Страница: 18 / 30

13
3.4 Wiring the Power Inputs
Please follow the steps below to insert the power wire.
1. Insert DC power wires into the contacts 1 and 5 with negative electrode of power and,
2 and 6 with positive electrode of power, contacts 1 and 2 are defined as power input
1 and contacts 5 and 6 are defined as power input 2, you can connect both power
input for redundancy but also can connect with single power input to power on switch.
2. Tighten the wire-clamp screws for preventing the wires from loosing.
[NOTE] The wire gauge for the terminal block should be in the range between 12 ~ 24
AWG.
- + - +