Lansinoh Signature Pro, Инструкция по эксплуатации

Страница: 13 / 48

12
5. USING THE LANSINOH® SIGNATURE PRO®
DOUBLE ELECTRIC BREAST PUMP
5.1 Power Options
The pump may be operated using the following power supply modes:
AC Adapter
1.
Connect the AC adapter to the power receptacle located on the right side of the pump.
Plug the AC adapter into an available electrical outlet.
2. Electrical safety can only be achieved when
the breast pump is connected to the AC
Power adapter supplied with the product.
(See “Technical Data” section, page 18)
AA Alkaline Batteries (not included)
1.
Make sure the batteries are inserted
correctly according to the polarity (+) and
(-) as indicated.
2. Close the compartment by gently pressing
the cover until it snaps into place.
•
Remove batteries if pump is not in use for a long
period of time.
•
Dispose of batteries according to regulations for
environmental protection and recycling.
•
Replace batteries as a simultaneous set. Do not
mix old and new batteries.
•
Do not mix alkaline and standard (carbon-zinc)
batteries.
•
If batteries are in the pump, but AC adapter is in
use, the pump will use the adapter to power the pump, not the batteries.
For the most economical use, we recommend using your pump with the AC adapter
provided. Your AC adapter is a universal AC plug adapter type and can be used with 100
VAC to 240 VAC systems with 50Hz and 60Hz mains.
5.2 Getting Started
If possible, wait until your breastmilk
supply and breastfeeding schedule are well
established. This is normally at least 3-4 weeks
after birth, unless told otherwise by your
doctor or breastfeeding advisor.
1.
Hold the Breastmilk Expression Set to your breasts so that the nipple is aligned to extend
straight toward the nipple tunnel of the breast flange.
2. Make sure the breast completely fills the breast flange so that a vacuum is formed and
no air escapes.
3. The Breastmilk Expression Set and nipple tunnel must tilt slightly downward to allow
milk to flow naturally toward the bottle.