Lanner NCA-5310, Руководство пользователя

Страница: 24 / 91

NCA-5310 User Manual
24
To reduce the risk of personal injury, electric shock, or damage to the system, please remove all power
connections to shut down the device completely. Also, please wear ESD protection gloves when conducting
the steps in this chapter.
1. Loosen the 2 thumb screws on the rear panel.
2. Gently pull the top cover backward a bit, and lift the cover up to remove it.
Please note that the system delivered to you is already installed with the processor and that this processor,
LGA3647, comes with rather sophisticated design; therefore, the assembly of which must be handled with
exclusive tools and extreme care by professionals. It is strongly recommended that you not make any
adjustments to, remove or even re-install the processor on your own. If handling the processor on your own is
inevitable, please read through the instructions in this section and refer to the
official tutorial released by Intel ®
to make sure you have acquired the necessary knowledge and comply with the requirements.
Installing the processor onto the motherboard involves two stages:
1. Mount the processor onto the heat sink to make a PHM (Pro Heat Sink Module)
2. Install the PHM onto the motherboard.
Note : The images of tools shown in this document are merely for reference; the actual tools you use might differ.
Tool Description
Torque screwdriver
(Star T30)
Set to 1.36 N.m. or 12 in-lbf for tightening the
nuts which fasten the PHM on the bolster plate.
ESD Protection
(ESD gloves, ESD-safe work
surface, etc.)
During the entire assembly process, at least
wear a pair of ESD gloves to avoid damaging or
contaminating the electronic parts while
enhancing your own safety.
1 1
2