Lanier Worldwide, Inc.
2300 Parklake Dr., N. E.
Atlanta, GA 30345-2979
Emergency Telephone: (800)526-4371
MATERIAL SAFETY DATA SHEET
1
Section 1: Chemical Product and Company Information
Identity:
Toner for 9060 POD
MSDS No.
CP-312
Product ID:
117-0237
Issued:
01/05/98
Synonyms
& Common
Names:
Uses:
Chemical
Formula:
Toner, Black Tonerer for Lanier
9060 POD
9060 POD
Mixture
Supersedes:
Date:
Prepared by:
European
Contact:
none
01/26/98
Lanier QA/EH&S Department
Lanier Worldwide, WSM Europe,
Walter Fricke,
Im Taubental D-41468 Neuss,
G49-2131-387-177
Section 2: Composition / Information on Ingredients
PERCENT
CAS No.
EXPOSURE LIMITS
SOURCE
Carbon black
6 - 8
1333-86-4
3.5mg/m
3
3.5mg/m
3
OSHA PEL ACGIH TLV
Polyester resin
75214-60-7
not listed
n/a
Polyester resin
<94
TSCA Confidential
Trade Secret No.
80100252-5001-P
n/a
Wax
9003-07-0
not listed
n/a
Pigment
31714-55-3
not listed
n/a
*PEL as the product: 15mg/m
3
(total dust), 5mg/m
3
(respirable dust)
*TLV as the product: 10mg/m
3
(total dust), 5mg/m
3
(respirable dust)
Section 3: Hazards Identification
Hazard Rating:
FIRE = 1 HEALTH = 1
REACTIVITY = 0 SPECIAL = none
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to any
non-toxic dust. May cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort.
Health Hazards of Long Term exposure (Chronic): A manufacturer sponsored chronic inhalation study in rats using a special test
toner revealed there were no lung changes at all in the lowest exposure level (1mg/m
3
), the most relevant level to potential human
exposures. A very slight degree of fibrosis was noted in 25% of the animals at the middle exposure level (4mg/m
3
), while a slight
degree of fibrosis was observed at the highest exposure level (16mg/m
3
) in all animals. These findings are attributed to “Lung
Overloading”, a generic response to excessive amount of any dust retained in the lungs for a prolonged interval. The special test
toner was ten times more respirable than commercially available toner to comply with EPA testing protocol and would not function
properly in Xerographic equipment.
Section 4: First Aid Measures
Inhalation:
Remove to fresh air if effects occur. Consult
local medical personnel
Eye Contact
:
In case of contact, immediately flush eyes with
water for 5 minutes.
Skin Contact:
Wash with soap and water.
Ingestion
:
Dilute stomach contents with water. Call a
physician
Section 5: Fire Fighting Measures
Suitable extinguishing media:
CO
2
, dry chemical, foam or water.
Extinguishing media which may not be used for safety reasons: none
