Lanier 5222, Руководство оператора

Страница: 48 / 102

Netware 4.x, 5- Advanced Settings
4 - 14 NetWare Configuration
•
Click [Assignments], and click [Add] in the [Assignments] group.
•
In the [Available objects] box, click the queue created in the step 11 to high-light
it, and click [OK].
•
After confirming the settings, click [OK].
16
Turn the printer power OFF and ON.
•
To confirm if the printer is configured correctly, enter as follows from the
command prompt. F:> NLIST USER /A/B
•
If the printer works as configured, the name of the print server appears as an
attached user.
Setting Up as Remote Printer
1
Log in to the file server as Admin.
2
Run the NIC Setup Tool.
3
Click [Property Sheet] and click [OK].
•
The Browse dialog of the Network Interface Card appears.
as follows.
4
Click [IPX protocol].
5
Select the IPX address of the Network Interface Card which is to be configured by clicking
it, and click [Next].
•
If you do not know which Network Interface Card you are configuring, print the
Configuration Page using the printer's operation panel, and select the MAC
address that is on the page.
6
Confirm that the MAC and IPX addresses are correct, and click [Finish].
•
[NIC Setup Tool] window appears.
7
Click [Configure].
•
The property sheet appears.
8
Click the [NetWare] tab, and make the following settings.
•
In the [Print Server Name] box, enter the name of the print server.
•
In the [File Server Name] box, enter the name of the file server in which a print
server is to be created.