Laney Black Country Customs THE DIFFERENCE ENGINE, Руководство пользователя

Страница: 26 / 37

Page 25
SETTINGS MENU
GLOBAL
•
GLOBAL ROUTING (ON / OFF)
o
Allows you to override all routing settings of each preset. This means the preset routing
mode will be ignored and instead a single routing type will be applied to all presets.
Useful if you only need one type of routing and don’t want to edit a load of patches.
Default is OFF.
•
ROUTING (Stereo, XFB, Ping Pong, Mono, Wet/Dry)
o
Selects the routing mode of the GLOBAL ROUTING override. See ROUTING 101 for more
information. Default is STEREO.
•
START UP PRESET (0 ~ 100)
o
Determines the preset recalled when the pedal is powered up. Setting the value to 0 will
load the last used preset on power up. Default value is
0 .
• TRAILS (ON / OFF)
o
Sets whether the delayed signal spill over when bypassing the delay effect. When on any
repeats will continue and die out naturally when bypassing the BCC-TDE. When off any
repeats will mute abruptly. Default value is
ON .
•
FREEZE TOGGLE (ON / OFF)
o
Changes the behaviour of the FREEZE function. When FREEZE TOGGLE is OFF you must
hold the FREEZE footswitch down to enable the freeze. When FREEZE TOGGLE is ON the
freeze will continue even after the footswitch is released. To stop the freeze function
holding the footswitch again is required. Default value is
OFF .
DISPLAY
• SCROLL SPEED (1 ~ 10)
o
Determines the speed at which the presets scroll through the display when holding either
of the footswitches in PRESET mode. 1 is slow scroll and 10 is fast scroll. Default value is
5 .
•
TIME DISPLAY (MS / BPM)
o
Sets the mode in which time is displayed on the display for all presets. MS shows the time
in milliseconds. BPM shows the time in beats per min. BPM is useful for Keyboard players
or in situations where a sequencer is being used.
•
BPM DIV (1/4, 1/8, 1/16, 1/4D, 1/8D, 1/4T, 1/8T)
o
Allows you to select the correct BPM division to achieve the desired delay effect for the
part you are playing. This is stored in each preset, so you can have different presets set to
different divisions. D = Dotted & T = Triplet. Default value is
1/4 .
•
DISPLAY CONTRAST (1 ~ 10)
o
Sets the brightness of the OLED display. The higher the value the brighter the display. You
can adjust this setting to suit your needs. Default value is
5 .
•
AUTO DIM (ON / OFF)
o
The AUTO DIM function will dim the screen after approximately 30 seconds of inactivity.
This helps to extend the lifetime of the screen and reduce power draw. Editing any control
or setting will un-dim the screen. If you want the screen to always be fully lit, then you can
disable this control. Default value is
ON .
EXPRESSION PEDAL
• ENABLED (ON / OFF)
o
Enables or disables any expression pedal control. If you are not using an expression
pedal, make sure this is set to OFF . Default value is OFF.
Note. If you unplug the expression pedal, be sure to disable this setting again.