Surface Mount
Tools Required
•
Safety glasses
•
Screwdrivers
•
Wiring tools and connectors
•
1/2” wrench or socket
•
Hammer drill, with 1/2” dia bit
•
2mm hex key
•
Epoxy anchoring system for concrete
•
Wire brush and compressed air for clearing anchor holes
•
Standard octagon junction box, installed (not included)
ASSEMBLE WITH CARE!
Pangard II
Polyester Powdercoat is a strong, long-lasting finish. To protect this finish
during assembly, place unwrapped powdercoated parts on packaging foam or other non-marring surface. Do not
place or slide powdercoated parts on concrete or other hard or textured surface – this will damage the finish
causing rust to occur. Use touch-up paint on any gouges in the finish caused by assembly tools.
LIGHTING LAYOUT RECOMMENDATIONS:
Path light spacing is the responsibility of others. Refer to the Motive Path Light
Product Data Sheet, available on
, for light
distribution options.
Installation Guide
Motive
Path Light
www.landscapeforms.com Ph: 800.521.2546
Date: November 19, 2019
Page 1 of 3
Fig. 3 – Base plate detail
[133mm]
Ø5-1/4”
BOLT CIRCLE
FRONT
OF LIGHT
Fig. 1 – Minimum footing recommendation
2-1/2”MAX
RECOMMENDED
CONDUIT CLEARANCE
1/2” – 3/4”
RECOMMENDED
CONDUIT SIZE
Included hardware
4x – concrete
anchor
4x – 5/16
washer
1x – path light
assembly
4x – 5/16-18 x
1” hex hd bolt
1x – anchor
template
Fig. 2 – Recommended setback
from sidewalk
SIDEWALK
