Landoll Icon 1024, Руководство по обслуживанию и запасным частям

Страница: 15 / 58

3-1
INDEX TABLE OF CONTENTS
Chapter 3
Assembly and Lubrication
It is very important that your new Box Scraper be properly
assembled, adjusted and lubricated before use.
Illustrations in this section show proper assembly
procedures. Remove paint from grease fittings. Replace
any grease fittings that are damaged or missing. Be sure
to return screws, clips, etc., to their original locations.
To insure alignment of assemblies, leave the nuts loose
until completion of final assembly. Use lock washers or
flat washers as specified. Spread all cotter pins.
After completion of final assembly, tighten all nuts
evenly
to prevent misalignment, distortion or binding.
Tighten all screws and nuts to the recommended torques
(See “General Torque Specifications (rev. 4/97)” on
page 2-2.)
.

CAUTION

WARNING

DANGER
Be sure to bleed the hydraulic system of all air in
lines after installation. Failure to bleed the system
of all air can result in improper machine
operation.
Do not attempt to lift heavy parts (such as the
frame, disc gangs, rock shaft, and pull hitch)
manually. Use a hoist or a fork lift to move these
parts into position.
To prevent accidental lowering:
1. All hydraulically elevated equipment must be
locked out using the cylinder lockouts:
2. Lower equipment to the ground while
servicing or when it is idle.
Failure to take measures to prevent accidental
lowering may result in serious personal injury or
death.