Landoll Brillion Turfmaker II Series, Руководство оператора

Страница: 77 / 114

9K998-2306 3-13
TABLE OF CONTENTS
Calibration for Unlisted
Seeds
IMPORTANT
The Clutch must be disengaged when Seed Shafts
are turned manually for Calibration.
Electrical Power
is required to disengage the Clutch.
Landoll assumes no liability pertaining to Seeding Rates
achieved with this Seeder. Rates listed are general in
nature and should be used as starting points only. Seed
varieties and blends listed represent those calibrated
through in-house test meters.
Variations in actual rates may be realized due to
differences in Seed Lots.
For accurate rates with seeds
being used, follow the Calibration Instructions listed
on the Seed Chart inside the Seed Box Cover or refer
to the Operator’s Manual.
NOTE
The information listed in the Seed Charts is subject to
change without notice.
IMPORTANT
Rates are for the 11 Tooth Driver. Double these
values for the 22 Tooth Driver. See Figures 3-1 and
3-2.
Front Seed Box may be Calibrated for Unlisted Seed
as follows.
1. Raise Seeder and install Transport Locks. See
Figure 3-6.
2. Disengage Electrical Clutch. Electrical Power is
required to disengage the Clutch.
3. It equipped, close Meters of Rear Seed Box if they
contain Seed.
4. Place a Canvas or Tarp under the Machine to catch
Seed.
5. Turn 11/16 hex Seed Shaft on the Transmission
Clockwise(CW). See Figure 3-13.
8FT Seeder: Use 47 turns if you follow Step 5.
Reference, the Seed Shaft rotates 470 Revolutions
per Acre Seeded with 11 Tooth Driver.
10FT Seeder: Use 37 turns if you follow Step 5.
Reference, the Seed Shaft rotates 370 Revolutions
per Acre Seeded with 11 Tooth Driver.
12FT Seeder: Use 31 turns if you follow Step 5.
Reference, the Seed Shaft rotates 310 Revolutions
per Acre Seeded with 11 Tooth Driver.
6. Weigh Seed (lbs) and Multiply by 10 (20 for 22 Tooth
Driver) for approximate Planting Rate in Pounds per
Acre.
Rear Seed Box may be Calibrated for Unlisted Seed
as follows.
1. Raise Seeder and install Transport Locks. See
Figure 3-6.
2. Disengage Electrical Clutch. Electrical Power is
required to disengage the Clutch.
3. Close Meters of Front Seed Box if they contain Seed.
4. Place a Canvas or Tarp under the Machine to catch
Seed.
5. Turn 11/16 hex Seed Shaft on the Transmission
Clockwise(CW). See Figure 3-14.
8FT Seeder: Use 47 turns if you follow Step 5.
Reference, the Seed Shaft rotates 470 Revolutions
per Acre Seeded with 11 Tooth Driver.
10FT Seeder: Use 37 turns if you follow Step 5.
Reference, the Seed Shaft rotates 370 Revolutions
per Acre Seeded with 11 Tooth Driver.
12FT Seeder: Use 31 turns if you follow Step 5.
Reference, the Seed Shaft rotates 310 Revolutions
per Acre Seeded with 11 Tooth Driver
.
6. Weigh Seed (lbs) and Multiply by 10 (20 for 22 Tooth
Driver) for approximate Planting Rate in Pounds per
Acre.