Landoll Brillion PAT 10, Руководство оператора, Страница: 25 / 38

OPERATION
F-948R0 3-5
LED 7 Pin AG Connector
If an operator plugs in the 7 pin connector, but the lights
do not seem to work right, check the below items to make
sure that there is a good connection with the 7 pin
connector.
• Make sure the tractor has a good clean receptacle,
free of dirt and corrosion.
• Make sure the 7 pin connector is inserted ALL the
way in. With tighter fitting pins, operator may think the
connector is all the way in, but isn’t really.
• Make sure the tractor receptacle cover latches over
the keyway on the 7 pin connector to hold the
connector in place.
Figure 3-5: 7 Pin AG Connector
Transport
1. Check and follow all federal, state, and local
requirements before transporting the Aerator.
2. The Aerator should be transported only by tractor
required for field operation. The implement weight
should not exceed more than 1.5 times the tractor
weight. Maximum transport speed for the Aerator is
20 mph for the implement.

CAUTION
3. When towing equipment in combination, the
maximum equipment ground speed shall be limited
to the lowest specified ground speed of any of the
towed implements.
4. Maximum transport speed shall be the lesser of
travel speed specified in the operator's manual,
speed identification symbol (SIS), information sign of
towed equipment, or limit of road conditions.
5. Slow down when driving on rough roads. Reduce
speed when turning, or on curves and slopes to
avoid tipping. Equipment altered other than the place
of manufacture may reduce the maximum transport
speed. Additional weight, added tanks, harrowing
attachments, etc. may reduce implement load
carrying capabilities.
6. A safety chain is provided with the implement to
insure safe transport.
• The safety chain should have a tensile strength equal
to or greater than the gross weight of the implement.
The chain is attached to the lower hitch clevis hole
with two flat washers between the clamp plates to
assure a tight connection. Always use a 1” diameter
Grade 8 bolt for this connection.
• Attach the safety chain to the tractor drawbar. See
Figure 1-2. Provide only enough slack in the chain
for turning. Do not use an intermediate chain support
as the attaching point for the chain on the tractor. Do
not pull the implement by the safety chain.
Regularly inspect the safety chain for worn, stretched, or
broken links and ends. Replace the safety chain if it is
damaged or deformed in any way.
Amber LED
LED Warning
Lights Harness
Flasher Control
Module
7Pin/4Pin
WP Harness
Red LED
Amber LED
Excessive speed may result in loss of control of
the tractor and implement, reduced braking
ability, or failure of the implement tire or
structure. Do not exceed the implement
maximum specified ground speed regardless of
the capability of the maximum tractor speed.