9D990-2401
2-1
Chapter 2
Assembly
CAUTION
WARNING
NOTE
Refer to the repair Parts Manual Chapter for identification
of parts and for the approximate relationship of the parts
in assembly. Your exact Pulverizer Model may vary
slightly from the illustration.
To ensure the alignment of assemblies, leave the nuts
loose until completion of final assembly. Use lock washers
or flat washers as specified. Spread all cotter pins.
After completion of final assembly, tighten all nuts evenly
to prevent misalignment, distortion or binding. Tighten all
screws and nuts to the recommended torques.
IMPORTANT
• If pre-assembled parts or fasteners are temporarily
removed, remember where they go. It is best to keep
parts separated.
• Check that all working parts move freely, bolts are tight
and cotter pins spread.
• Refer to the Torque Table for proper torque valves.
Note the different torque requirements for Bolts with
Locknuts.
See "General Torque Specifications" on
“Left” and “Right” refer to directions seen as if standing
behind the machine and facing in the direction of forward
travel.
Do not work on or under this machine unless
securely blocked and supported by a hoist or
tractor or by other sufficient means.
Do not attempt to lift heavy parts (such as the
frame, rock shaft, and pull hitch) manually. Use a
hoist or a fork lift to move these parts into
position.
Содержание Brillion CPPR2-5
