Landoll Brillion CPP7, Руководство оператора

Страница: 28 / 46

2-16 7D525
ASSEMBLY
LED Warning Lights Installation
NOTE
All models similar. Refer to Figure 2-19 for bracket and
light placement.
1. Attach the 2 (two) Light Brackets to the rear frame
using the 1/2-13 U-Bolts and Nuts. On the 11’ Models
the Light Brackets are attached the 2 (two) foot
extensions.
See Figures 2-20, 2-21, and 2-22 .
2. Attach Amber LED to the outside of the Light Bracket
using (4) 1/4-20 x 1 1/4 Screws and Lock Nuts, then
attach the Red LED next to the Amber LED using (4)
1/4-20 x 1 1/4 Screws and Lock Nuts
3. Attach the Light Module to the Module Bracket using
(2) 1/4-20 x 1 1/2 Screws and Lock Nuts.
4. Attach the Module Bracket to the top of the rear
frame using 2 (two) 3/8-16 U-Bolts and Flange Nuts.
5. Layout the Lamp Harness, noting that the connectors
marked with Green Tape is Right Side and Yellow
Tape is Left Side.
6. Plug the Lamp Harness into the Light Module, route
both cord plugs with Green Tape along the top right
side of the rear frame. Route the plugs up through
the Light Bracket and plug the 3 prong cord into the
Red LED. Plug the 2 prong cord into the Amber LED.
7. On the 11’Model, route both cord plugs with Green
Tape along the top right side of the rear frame. then
up the outer right frame, then over to the 2’extension.
Route the plugs up through the Light Bracket and
plug the 3 prong cord into the Red LED. Plug the 2
prong cord into the Amber LED.
8. Repeat for the Left Side (Yellow Tape).
9. Plug the 7 Pin Harness into the Light Module, then
route the harness along the Right Hand Brace and
secure with Tie Straps.
10. Bundle and secure excess cord to the Module
Bracket with Tie Straps. Secure cords along frame
and brace using Tie Straps.
All wires must be firmly attached to machine frame
members so they do not sag or become torn loose by
field debris.