Landoll Brillion 4630-36 Series, Руководство оператора

Страница: 21 / 40

OPERATION AND MAINTENANCE
4-3
Attaching Seeder Hitch To The
Tractor

DANGER

WARNING
1. Make sure the tractor drawbar is rated and adjusted
properly for the weight of the seeder hitch
.
2. Measure the tractor drawbar and adjust the hitch
clevis to the appropriate hitch mounting holes.
3. Carefully back the tractor into position. If the draw bar
is too high or too low, attach the hydraulic hoses to
the tractor. Slowly extend or retract the telescoping
hitch until the hitch is in line with the tractor clevis.
Figure 4-1: Hydraulic Leak Detection

WARNING
4. Back the tractor into final position, and install the
hitch pin.
5. Connect 7 pin light plug to tractor 7 pin outlet, routing
cable by avoiding pinch points.
• Make sure the tractor has a good clean receptacle,
free of dirt and corrosion.
• Make sure the 7-pin connector is inserted ALL the
way in. With tighter fitting pins, operator may think the
connector is all the way in, but really isn’t.
• Make sure the tractor receptacle cover latches over
the keyway on the 7-pin connector to hold the
connector in place.
• If an operator plugs in the 7-pin connector, but the
lights do not seem to work right, check the above
items to make sure there is a good connection with
the 7-pin connector.
6. Attach the safety chain to an anchor on the tractor
sufficient to pull the seeder.
7. Fully raise the hitch and install the transport lock pin
in the hitch.
8. Rotate the parking jack stand into storage position
and pin in place.
Do not allow any bystanders to stand between the
tractor and the implement while backing up to the
implement.
The Seeder Hitch has positive and negative
tongue weight depending on wing fold position.
Use a locking-style hitch pin that is properly sized
for the tractor drawbar and implement hitch.
d5842a
Escaping fluid under pressure can penetrate the
skin causing serious personnel injury. Avoid the
hazard by relieving system pressure before
disconnecting hydraulic lines. Tighten all
connections before applying pressure. Keep
hands and body away from pinholes which eject
fluid under high pressure. Wear protective gloves
and safety glasses when working with hydraulics.
Use a piece of cardboard or paper, not body parts
to search/check for leaks. (See Figure 4-1.) If an
accident occurs, see a doctor immediately. Any
fluid injected into the skin must be surgically
removed within a few hours or gangrene may
result.