Landoll Bendi B40i4, Руководство оператора

Страница: 20 / 66

2-2 F-808-R0
RECEIVING AND INSPECTION
Lubricate all grease fittings and metal-to-metal surfaces
located outside the truck. Refer to “Rotation Bearing
Grease Points” on page 5-7 for lubrication information.
General System Checks
With the truck Keyswitch set to OFF and the direction
control switch set to NEUTRAL, perform a walk-around
inspection. Always pay strict attention to all CAUTION,
WARNING, and DANGER decals affixed to the truck and
thoroughly read the SAFETY chapter of this manual.
Check for obvious damage that would require more
detailed inspection.
If you notice a problem, immediately report it to your
supervisor, record it in the truck log book and have it
checked or repaired before releasing the truck for use.
Driver’s Seat
• Check the seat covering and seat belt for rips or cuts.
• Check that the seat belt is firmly attached and that
the buckle is not damaged.
• Check that the seat belt works properly.
The driver’s seat switch system includes an interlock that
shuts down the drive and disables the direction control
(resets to NEUTRAL and requires you change the
direction lever again to establish direction) bringing the
truck to a smooth STOP.
The mast functions remain operable.
To check the seat switch interlock:
1. Sit in the driver’s seat and start the engine.
2. Set the direction control lever to FORWARD and
slowly depress the drive pedal until the truck begins
to move.
3. Lift yourself from the seat far enough to release the
seat switch.
4. Press the drive pedal and notice you must return the
direction switch to neutral and then back to forward
(or backward) for motion control to return. If this is
not observed, immediately report this to your
supervisor and record it in the truck log book. Have
this operation checked and repaired before releasing
the truck to use.
Fasteners
Check for damaged, loose or missing screws, bolts and
nuts. Tighten and/or have service replace as needed.
Horn, Lights, Etc.
Check lights for proper on/off operation and for blown
bulbs. Check that the horn sounds when pressed. Repair
and/or replace as needed.
Hydraulic Lines and Loose
Fittings
Check underneath the truck for evidence of fluid leaks.
Look for hydraulic hose wear, damage and leaks.
Make sure clamps and fittings are tight. If leaks are
found, have maintenance repair all leaks immediately
and check the hydraulic fluid level. Do not use the truck.
Hydraulic Oil Level
Check the oil level weekly. Low oil can cause operational
problems. See “Hydraulic Oil” on page 5-4.
Dash Display
Inspect the dash display for errors, faults and damage to
ensure normal operation.
Stopping
With the engine running, drive forward slowly and then
release the drive pedal. The truck should stop smoothly
without noticeable side pull or vibration.
Mast Operation
With the engine running, raise the mast. Check that the
primary cylinder extends fully and that the lift carriage
rises to the top of the inner rails before the secondary
cylinders begin to move.

WARNING
• When the lift carriage reaches the top of the inner rails,
the secondary cylinders and middle rails begin lifting.
Check to make sure the rails travel smoothly and that
there is no chatter or visible binding.
• With the mast fully extended, begin lowering the mast.
The secondary cylinders and middle rails fully lower
first, followed by the primary cylinder and the lift
carriage. Check for smooth travel with no chattering or
visible binding.
Never place your head, hands, arms or feet in the
mast area. Make sure there is sufficient room
above to raise the mast safely.