Landoll 876 Series, Руководство оператора

Страница: 45 / 58

4-3 ATTACHING TO THE TRACTOR
4-3.1 Align the tractor drawbar with the ma-
chine. Raise or lower the Tilloll ring hitch, as
needed, using the swivel jack. Attach the unit
with proper size hitch pin.
4-3.2 Clean all hydraulic couplings and attach
to the tractor. When properly attached, the
hydraulic control lever should cause the
Tilloll to:
4-3.3 Lower to the ground when the control
arm is moved forward or downward, and
4-3.4 Raise when the control arm is moved
backward or upward.
4-3.5 Always place the swivel jack on the in-
terior mount before setting the machine in
motion.
4-4 TRANSPORT
4-4.1 Raise the unit to full transport height.
4-4.2 Fold the wings.
IMPORTANT
WHEN FOLDING OR UNFOLDING WINGS, OP-
ERATE TRACTOR ENGINE AT A FAST IDLE ON
30’, 35’, AND 40’ UNITS, AND HOLD HYDRAU-
LIC VALVE ON TRACTOR OPEN TO ASSURE
SMOOTH OPERATION.
4-4.3 Place the transport lock brackets on the
rods of the lift cylinders on the main frame
and pin in place. (See Figure 4-2).
WARNING
FAILURE TO USE TRANSPORT LOCK
PINS DURING TRANSPORT MAY RE-
SULT IN PERMANENT EQUIPMENT
DAMAGE, SERIOUS INJURY, OR
DEATH.
IMPORTANT
WHEN TRANSPORTING FARM IMPLEMENTS
ON PUBLIC ROADS, IT IS THE RESPONSIBIL-
ITY OF THE OPERATOR TO ABIDE BY STATE
AND LOCAL LAWS CONCERNING WIDE LOAD,
SPEEDS, AND SAFETY LIGHTING EQUIPMENT.
THE SLOW MOVING VEHICLE SIGN CAN BE
ATTACHED TO THE IMPLEMENT WHEN NEC-
ESSARY.
4-3