Landoll 876 Series, Руководство оператора

Страница: 39 / 58

3-10 WARNING LIGHTS INSTALLATION
3-10.1 Assemble lights to the warning light
bracket using 1/4-20 X 1-1/4 hex head cap
screws and hex lock nuts. Insure the wires
are in the groove in the base of the light to-
ward the mounting surface on the bracket.
Assemble one light for left side and one for
right side. The red light should be to the rear
with the amber light being the outer most
light (See Figure 3-11) .
3-10.2 Install a red reflector and an orange
stripe on the rear side of each warning light
bracket.
3-10.3 Install a yellow reflector on the front
side of each warning light bracket.
3-10.4 Assemble mounting bracket angle to
warning light bracket assembly using 1/2-13
x 1-1/2 hex head cap screws and hex lock
nuts.
3-10.5 Assemble warning light bar and warning
light bracket assembly to outer rear of frame
as shown in Figure 3-11 using 1/2-13 x
5-1/2 hex head cap screws and hex lock
nuts.
IMPORTANT
MAKE SURE LIGHTS ARE POSITIONED FOR
MAXIMUM VISIBILITY FROM THE REAR.
3-10.6 Install the rear wiring harness between
the lights. Note: A 30" extension is re-
quired to one side on all models.
3-10.7 Install the main harness by starting at
the hitch and routing the harness through the
hose loops to the extension harness.
3-10.8 Insure the harnesses are clear of any
moving parts and secure the harnesses with
tie wraps provided.
3-21