Landoll 330C, Руководство оператора

Страница: 23 / 64

OPERATING INSTRUCTIONS
3-13
Figure 3-7: Remote Control Transmitter
Table 3-1: Transmitter Error Code Chart
Table 3-2: Receiver Error Code Chart
5. Synchronizing transmitter and receiver:
There are over 64,000 different addresses (id codes)
available for each transmitter and receiver pair. Each
transmitter and receiver pair is synchronized together at
the factory. If a new transmitter is needed, synchronizing
is required. Use the following procedure:
a. With power applied, press the red button on the
receiver for >5 seconds until LED’s toggle.
b. With the transmitter off, press and hold the
POWER button for >10 seconds until LED’s blink,
then release.
c. Wait for a few seconds until the green LED’s
begin to blink.
d. Teach complete.
IMPORTANT
On winches with the air tension option, the winch
tension is engaged automatically when the switch is
turned to winch in/out. The winch tension switch on
either the remote or the control panel must be used
to disengage the winch.
Transmitter Error Code Chart
Error Code Probable Cause
1 Low Battery
2 Tilt Down Fault
3 Tilt Up Fault
4 Winch Out Fault
5 Winch In Fault
6 Axle Back Fault
7 Axle Ahead Fault
Receiver Error Code Chart
Error Code Probable Cause
1 RF Communication Problem
2 Tilt Down Fault
3 Tilt Up Fault
4 Winch Out Fault
5 Winch In Fault
6 Axle Back Fault
7 Axle Ahead Fault
TRANSMITTER
6 FUNCTION
DECAL
RED ERROR
CODE LIGHT
GREEN SIGNAL
LIGHT
330C remote control op