Landoll 330B, Руководство оператора

Страница: 23 / 64

3-12.2 The HYDRAULIC WINCH CONTROL
lever (See Figure 3-2) is the center lever. It
is a three position control:
UP In this position, cable is “power”
spooled onto the spool.
CENTER This is neutral position.
DOWN In this position, cable is “power”
spooled off the spool.
3-13 AUXILIARY HYDRAULIC POWER ENGINE OPERATION
3-13.1 The Hydraulic Power Supply Engine is
used to power the hydraulic functions, should
the tractor not be equipped with hydraulic
hookups.
IMPORTANT
1. CHECK THE FOLLOWING FLUID LEVELS BE-
FORE STARTING THE ENGINE PACKAGE: EN-
GINE OIL, FUEL SUPPLY, HYDRAULIC OIL.
(CHECK OIL LEVEL WHILE SEMITRAILER IS
NOT TILTED AS TILTING WILL CHANGE THE
OIL LEVEL IN THE TANK.)
2. IF THE ENGINE DOES NOT CRANK, CHECK
THE FOLLOWING ON THE BATTERY: CHARGE,
FLUID, TERMINALS, AND CABLES. TAKE COR-
RECTIVE ACTIONS AS NEEDED.
CAUTION
IF THE HYDRAULIC FLUID LEVEL IS
LOW DURING OPERATION, THE SEMI-
TRAILER MAY NOT OPERATE COR-
RECTLY, RESULTING IN DAMAGE TO
THE SEMITRAILER.
3-13.2 The Engine Ignition Switch, Choke and
Throttle are on the Engine Control Panel
mounted on the drivers side of the engine
package. (See Figure 3-6).
3-13.3 The HYDRAULIC POWER SUPPLY
ENGINE THROTTLE controls the speed at
which the engine operates (See Figure 3-6) .
It is a variable position control:
HIGH In this position, the engine throttle is
fully open, letting it run at full speed.
LOW In this position, the engine throttle is
closed, letting the engine run at a
slow idle.
3-11
Figure 3-4 12,000# Winch Clutch
DISENGAGE
ENGAGE
Figure 3-5 20,000# Winch Clutch
ENGAGE
DISENGAGE