ASSEMBLING YOUR L&L EASY-FIRE KILN
easy-fire-install.pdf
3/1/2007 Rev 1.3
Page 13
2007
L&L Kiln Mfg, Inc. 505 Sharptown Rd, Swedesboro NJ 08085 P:856.294.0077 F:856.294.0070 [email protected] hotkilns.com
4) Get together your spring, hinge rod, hinge cotter
pins and hinge spring tool (that is the long 1/2”
diameter metal rod with the machined slot in the
end).
5) Next you are going to take the spring and put it
inside the lid hinge piece making sure that the short
end of the spring is in the hole to the left of the
hinge piece as your looking at it.
6)
Place the hinge bar through the large hinge piece,
through the spring and out the other end of the large
hinge piece. Insert the cotter pins into the holes in
each end of the hinge bar.
It is critical that the hinge bar sits in the bottom
of the slot . This allows the lid to raise and
lower as the kiln body expands with the heat .
Otherwise the kiln lid could be damaged during
firing .
8) Raise the large ring hinge piece up until the hinge
bar sits in the
bottom of the slot .
While holding the
large ring hinge piece in place tighten the screws .
ASSEMBLING YOUR L&L EASY-FIRE KILN
