Landis S755 XL (G2), Руководство оператора

Страница: 18 / 28

Operator Manual S755 (G2) / S755 XL (G2) October 2017
Landis International - 18
4. Verify if the drawer is perfect adjusted to the seal. It’s possible
to adjusted the level of the drawer. Screw or unscrew the set
screw with an Allen Key. Make sure the block bellow is aligned
to the ledge.
5. Check seal sound drawer and replace if damaged or if it is not
sealed properly.
6. Check seal between the top of the drawer and the dust bag.
7. When the dust drawer is full, dust may spill when the drawer is
removed. Vacuum out the bottom of the machine before
sliding back the drawer.
N.B. The cleaner you keep the dust bag, the less likely you are to burn a
hole in them. Failure to shake the dust bag and empty the dust drawer daily
will only increase this likelihood, but also cause a significant loss of dust
extraction from the sanding, trimming and brushing areas.
RUBBER AND FELT WHEEL
Clean the rubber/felt surface to avoid accumulation of dust. If
there is too much accumulation, the sanding be
lt won’t stay on
the rubber/felt wheel and you will have problems with tracking.
IDLER WHEEL
Clean the flat surface to avoid accumulation of dust with a
scraper.