Landis S755 XL (G2), Руководство оператора

Страница: 16 / 28

Operator Manual S755 (G2) / S755 XL (G2) October 2017
Landis International - 16
ACCESSORIES
• EYE PROTECTION SHOULD ALWAYS BE WORN BY THE OPERATOR AND OTHERS IN
THE WORK AREA WHEN USING THE ACCESSORIES SUPPLIED WITH THE LANDIS
FINISHER. EYE PROTECTION IS REQUIRED FOR PROTECTION FROM FLYING DEBRIS
AND DUST, WHICH COULD CAUSE EYE INJURY.
ALL ACCESSORIES ARE MOUNTED ON BAYONET FITTING
One end of the sanding shaft is machined to accommodate bayonet fitting
(quick change). Extra tools and sanding wheels are available on request.
When removing the quick change fittings, use the special black spanner wrench
(CCL) supplied with the machine. To remove, engage the spanner in the hole
near the end of the bayonet fitting and apply a sharp rap downward. Before
putting on a fitting be sure the opening ends are cleaned. Hand tightening is
sufficient to hold the fitting in proper position.
N.B. When properly mounted, the bayonet fitting will tighten itself by rotating it in the socket in the
opposite direction of the sanding belt rotation.
• FAILURE TO PROPERLY MOUNT THE ADAPTOR WILL RESULT IN FLYING APART AND POSSIBLE INJURY TO THE
OPERATOR AND OTHERS IN THE WORK AREA.
• THESE QUICK CHANGE ACCESSORIES SHOULD BE PROPERLY ENGAGED ON THE SHAFT TO ENSURE SAFE
OPERATION. MAKE SURE PIN ON SHAFT ENGAGES THE ADAPTOR CORRECTLY.
• THE ACCESSORY MUST BE POSITIONED IN THE MAIN SHAFT SO THAT IT TIGHTENS ITSELF AS IT IS BEING USED.
HEEL BREASTER ON BAYONET
A Heel breaster mounted on a quick change adaptor is
provided with your Finisher and can be
used only on the left side
of the main shaft.
/
The breaster has a left handed screw assembly, designed to
tighten during rotation only on the left side of the machine.
Be careful to install the half-moon sandpaper in the groove of the aluminium
breaster. Failure to properly install it will cause vibration when sanding.