Landice 90 Series, Руководство пользователя, Страница: 20 / 114

Introduction
20
1.3.2. Contact Heart Rate Monitoring System
The Contact Heart Rate Monitoring System is designed for use
at walking speeds. A natural running motion involves using
your arms to maintain balance. Because the Contact Heart
Rate Monitoring System requires your arms to remain
stationary, we recommend using the pulse grips at speeds of
less than approximately 4 mph (6.4 km/h) or the fastest speed
at which you are comfortable walking.
The Contact Heart Rate Monitoring System can be used in
place of the wireless chest strap to perform any of the following
functions:
• Monitor your Time in Zone
• Heart Rate Control (HRC) program adjustment
• Help you maintain your Target Pulse
To use the Contact Heart Rate Monitoring System:
1. Switch to any screen that shows Pulse.
2. Grab the pulse grip portion of the center rail. When you
place your hands on the grips the display flashes. The
pulse will “beat” briefly and then display your heart rate.
Your heart rate will be continuously monitored while your
hands remain on the grips.
The HRC programs make speed and elevation adjustments to
maintain your target heart rate while your hands remain on the
grips. If you remove your hands the HRC programs will not
change speed or elevation until you place your hands on the
grips. These programs are available on the Cardio and
Executive models.
Note:
If you are wearing the wireless chest strap, the heart rate
from the pulse grips overrides the wireless signal from the
chest strap while your hands are on the pulse grips. When
you release the grips, the treadmill uses the wireless chest
strap signal for pulse calculation.