Landice 90 Series, Руководство пользователя, Страница: 35 / 114

Installation
35
• If the bubble goes to the right (while standing on
treadmill), adjust the left rear foot. Loosen the 19mm
nut by turning it clockwise and rest it against the 14mm
nut. Turn the 14mm nut clockwise to raise the foot. Stop
adjusting the foot when the bubble is centered on the
level.
• If the bubble goes to the left (while standing on
treadmill), adjust the right rear foot. Loosen the 19mm
nut by turning it clockwise and rest it against the 14mm
nut. Turn the 14mm nut clockwise to raise the foot. Stop
adjusting the foot when the bubble is centered on the
level.
19. Confirm that the bubble is centered on the level.
20. Lock each leveling foot into place by threading the 19mm
nut until it touches the bottom of the frame. Turn the 19mm
nut counterclockwise and 14mm nut clockwise using an
open end wrench to lock each foot into place.
21. Before checking treadbelt tension, make sure treadmill is
level. (See steps 17 through 20.) At proper tension you
should be able to place your hand between the belt and
deck and reach the center of the treadmill (Figure 2-16).
•
If you cannot reach the center, the belt is too tight.
• If your hand reaches past the center, the belt is too
loose.
Figure 2-16. Treadbelt Tension Check