Landa SDHW Series, Руководство оператора

Страница: 6 / 40

6
Safety
Pre-operation Check
- Pump oil (SAE 10W-40 non-foaming oil)
- Hose, wand, nozzles (nozzle sizes per serial
plate)
- Water filter (intact, non restrictive)
- Engine Oil (15W - 40 CD/SE)
- Engine/Burner fuel - ultra low sulfur diesel
Set-up Procedures
1. Attach a 3/4" water supply hose to garden hose
connector. Minimum flow should be 6 gpm. Or,
connect hose between pressure washer and water
filled pillow tank as shown on page 5.
2. Attach high pressure hose to shut-off gun nipple
using screw coupler. Lock coupler securely into
place.
3. When connecting pressure washer to pillow tank,
prefill connection hose with water. This will assist
the pump to draw water quicker. A dry pump is
hard to prime.
4. Attach swivel connector on discharge hose to
spray gun using teflon tape on threads.
5. Check oil level on sight glass on rear of pump. Oil
should be visible half way up sight glass (SAE
10W-40 non-detergent).
6. Check engine oil.
7. Fill diesel fuel tank.
8. Install proper battery making sure that the red
cable is attached to the positive terminal. Use only
a group 24 battery with a 90 amp hour rating.
9. Adding exhaust vent pipe to your oil fired burner is
not recommended because it restricts air flow. This
causes carbon build-up, which affects the opera -
tion, and increases maintenance on the coil. If a
stack must be used, refrain from using 90 degree
bends. If the pipe can not go straight up then use
only 45 degree bends and go the next size pipe.
The overall pipe length must not exceed 6 feet in
length.
10. These machines are intended to be protected from
the outside environment.
Landa SDHW6-35824 E/M Operator’s Manual 8.913-958.0 - AC