LANCOM L
-
300 Access Point Serie
Chapter 2: Installation
27
EN
The following can be displayed for WLAN data:
ETH
LAN connector status:
WPS
Messages via the WiFi Protected Setup (WPS). This function is not yet available
with early shipments. Please download the latest firmware and the associated
user manual from
.
Device con-
nectors
LANCOM L-305agn Wireless and LANCOM L-310agn Wireless
The rear panel accommodates the L-300 Access Point's connectors. The
models LANCOM L-305agn Wireless and LANCOM L-310agn Wireless are
equipped with the following connectors:
Device example:
LANCOM L-310agn
Wireless
LANCOM L-310agn
Wireless only
Connector for the first external antenna
Connector for the supplied power adapter
Ethernet socket ( 10/100/1000Base-Tx) for connection to the LAN.
The available transfer rate is detected automatically (autosensing).
The LAN connectors support the Power over Ethernet standard (PoE).
Further information about the operations with PoE can be found in the
information box
→
'Power over Ethernet—elegant power supply over
LAN cabling'.
Green
Flickering
TX data traffic.
Red
Flickering
Error in wireless LAN (TX error, e.g. transmission error
due to a poor connection)
Red
Blinking
Hardware error in the WLAN module
Off
No networking device attached
Green
On (perma-
nently)
Connection to network device operational, not data traffic
Green
Flickering
Data traffic
Reset
ETH
Config (COM)
WPS
Ant 1
Ant 2
Ant 3