Lancom 821+, Руководство пользователя

Страница: 22 / 76

LANCOM 821+ – LANCOM 1711+ VPN – LANCOM 1721 VPN
Chapter 2: Installation
21
EN
Reset switch
The reset switch has two different functions depending on the length of time
that it is pressed:
Restarting the device (soft reset) – push the button for less than five
seconds. The device will restart.
Resetting the configuration (hard reset) – push the button for more
than five seconds. All the device's LEDs will light up green and stay
on. As soon as the reset switch is released, the device will restart with
factory default settings.
Reset button functions
The reset button offers two basic functions—boot (restart) and reset (to the
factory settings)—which are called by pressing the button for different
lengths of time.
Some devices simply cannot be installed under lock and key. There is conse-
quently a risk that the configuration will be deleted by mistake of a co-worker
presses the reset button too long. With the suitable setting, the behavior of
the reset button can be controlled.
Reset button
This option controls the behavior of the reset button when it is pressed:
Ignore: The button is ignored.

Please observe the following notice: The settings 'Ignore' or 'Boot
only' makes it impossible to reset the configuration to the factory set-
tings. If the password is lost for a device with this setting, there is no
way to access the configuration! In this case the serial communica-
tions interface can be used to upload a new firmware version to the
device—this resets the device to its factory settings, which results in
the deletion of the former configuration. Instructions on firmware
uploads via the serial configuration interface are available in the LCOS
reference manual.
Configuration tool Call
WEBconfig, Telnet Expert configuration > Setup > Config