LANCOM 1811n Wireless – LANCOM 1821n Wireless
Chapter 2: Installation
29
EN
Online
The online LED displays the general status of all WAN interfaces:
The power LED is blinking and no connection can be
made?
If the power LED blinks red and no WAN connections can be
established, there is no cause for concern. This merely means
that a pre-set charge or time limit has been reached.
There are three ways to remove the lock:
Reset the toll protection.
Increase the limit.
Deactivate the lock completely (set limit to '0').
LANmonitor shows you when a charge or time limit has been reached. To reset the toll protec-
tion, activate the context menu (right-mouse click)
Reset charge and time limits
. The charge
settings are defined in LANconfig under
Management
Costs
(these settings are only avai-
lable if the 'Complete configuration display' is activated under
Tools
Options
).
With WEBconfig, charge protection and all parameters are to be found under
LCOS menu tree
Setup
Charges
Reset budgets
.
Power
P
ower
Signal that a
charge or time
limit has been
reached
Off
No active connection
Green
Flashing
Opening the first connection
Green
Inverse flashing
Opening an additional connection
Green
On (perma-
nently)
At least one connection is established
Red
On (perma-
nently)
Error establishing the last connection
Orange/
green
In the housing
cover; blinking
alternately with
the power LED
At least one WLAN module is in managed mode and has not
found a WLAN Controller yet. The corresponding WLAN
module(s) is/are switched off until a WLAN Controller is
found to supply a configuration, or until being switched
manually into another operating mode.
Orange /
red
In the housing
cover; blinking
alternately with
the power LED
At least one WLAN module is in managed mode and has
found a WLAN Controller. However, the WLAN Controller
cannot assign a configuration because the firmware and/or
the device's loader version is not compatible with the WLAN
Controller.
