LANCOM 1722 VoIP – LANCOM 1724 VoIP
Chapter 2: Installation
46
EN
ISDN connections
Default LANCOM 1722 VoIP
ISDN 1: TE mode, equivalent to external ISDN connection
ISDN 2: NT mode, equivalent to internal S
0
Default LANCOM 1724 VoIP
ISDN 1 and ISDN 2: TE mode
ISDN 3 and ISDN 4: NT mode
ADSL port (ADSL, ADSL 2, ADSL 2+)
Reset switch
The reset switch has two different functions depending on the length of time
that it is pressed:
Restarting the device
(soft reset) – push the button for less than five
seconds. The device will restart.
Resetting the configuration
(hard reset) – push the button for more
than five seconds. All the device's LEDs will light up green and stay
on. As soon as the reset switch is released, the device will restart with
factory default settings.
2.4
Hardware installation
Installation of the LANCOM Router involves the following steps:
LAN
– first of all connect your LANCOM Router to the LAN or to an indi-
vidual PC. Plug in one end of the supplied network cable (green connec-
tors) to a LAN connector on the device
, and the other end into an
available network connector socket in your local network, a free socket on
a switch or hub, or the networking connector of an individual PC.
The LAN connectors use autosensing to recognize the data rate (10/100
Mbit) and the type (node/hub) of attached network devices. It is possible
to connect devices of different speeds and types in parallel.
Avoid having multiple unconfigured LANCOM at once within a single
network segment. Any unconfigured LANCOM takes on the same IP
address (ending in '254'), and so address conflicts could arise. To
avoid problems, multiple LANCOMs should be configured one after
Содержание 1722 VOIP
Страница 1: ...LANCOM 1722 VoIP LANCOM 1724 VoIP...